Reference Guide

Recommended
Response Action
If the job was not cancelled manually, then Lifecycle Controller may be in Recovery mode. To
verify or change Recovery mode, use F2 Setup to select iDRAC Configuration then Lifecycle
Controller Settings.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP029
Message A Job of JobType arg1 already exists.
Arguments
• arg1 = parameter
Detailed
Description
Only one Job of the JobType requested can be created or scheduled at any time. A job of the
same type already exists in the job queue.
Recommended
Response Action
Wait until the existing job is complete or delete the existing job and then retry the operation.
Category Audit
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
JCP030
Message Cannot schedule jobs while an iDRAC update or configuration job is running.
Detailed
Description
Existing jobs cannot be scheduled while an iDRAC update job is running.
437