Reference Guide

Recommended
Response Action
Check for problems with the cables. See the Cables attached correctly section for more
information on checking the cables. You should also check to see if the enclosure has
degraded or failed components. To do this, select the enclosure object in the tree view and
click the Health subtab. The Health subtab displays the status of the enclosure components.
Verify that the controller has the supported driver and firmware versions installed and that
each Enclosure Management Modules (EMMs) are running the same version of supported
firmware.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
ENC7
Message The arg1 alarm was enabled.
Arguments
• arg1 = Enclosure Name
Detailed
Description
You have enabled the enclosure alarm. This alert is provided for informational purposes.
Recommended
Response Action
No response action is required.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
341