Reference Guide

Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE FALSE FALSE FALSE FALSE
BAT1032
Message The battery temperature on arg1 is normal.
Arguments
• arg1 = controller name
Detailed
Description
The battery temperature is within the normal operating range.
Recommended
Response Action
No response action is required.
Category Storage
SubCategory BAT = Battery Event
Severity Severity 3 (Informational)
Trap/EventID 4275
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE FALSE FALSE FALSE FALSE
BAT1033
Message The battery on arg1 was removed.
Arguments
• arg1 = controller name
Detailed
Description
The controller cannot communicate with the battery. Either the battery was removed, or the
contact point between the controller and the battery is degraded.
Recommended
Response Action
Make sure that the battery is present and properly connected. If the battery is present, wait for
a few minutes and re-check if the battery is detected. If the contact point between the battery
and the controller is degraded, you must replace the battery, the controller, or both. Refer to
the storage hardware documentation for information on how to safely access, or remove.
Contact technical support if the issue persists.
Category Storage
SubCategory BAT = Battery Event
170