Reference Guide

Detailed
Description
iDRAC7 is busy and does not respond to iDRAC7 configurator IPMI requests.
Recommended
Response Action
Try AC power cycling the server or upgrade the iDRAC firmware.
Category Configuration
SubCategory SWC = Software Config
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
SWC0001
Message Unable to save the network settings.
Detailed
Description
The network cable may not be connected or an internal error occurred. For more information
about the failure, see Lifecycle Log.
Recommended
Response Action
Verify the network cable is connected and retry the operation. If the problem persists: 1) Turn
off the system and disconnect the power cord. 2) Wait for five seconds. 3) Reconnect the
power cord, turn on the system, and retry the operation.
Category Configuration
SubCategory SWC = Software Config
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
SWC0002
Message Unable to set Part Replacement policies.
Detailed
Description
The Part Replacement policy configuration operation encountered an unexpected error while
communicating with iDRAC.
1151