Reference Guide

Detailed
Description
For any iDRAC user, SNMPv3 authentication protocol can be changed to "None" only if the
SNMPv3 privacy protocol state is set to "None".
Recommended
Response Action
Change the SNMPv3 privacy protocol state to None using "racadm set
iDRAC.Users.<index>.SNMPv3PrivacyType none", and retry the operation.
Category Configuration
SubCategory RAC = RAC Event
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
RAC1014
Message The SNMPv3 privacy protocol cannot be configured to AES or DES mode if SNMPv3
authentication protocol state is set to "None".
Detailed
Description
The SNMPv3 privacy protocol cannot be configured to AES or DES mode if SNMPv3
authentication protocol state is set to "None".
Recommended
Response Action
To configure the SNMPv3 Privacy Protocol for a specified iDRAC user, change the SNMPv3
Authentication Protocol to either MD5 or SHA state using "racadm set
idrac.users.<index>.SNMPv3AuthenticationType <value>".
Category Configuration
SubCategory RAC = RAC Event
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
RAC1016
Message The specified user already exists. Duplicate user names are not allowed.
Detailed
Description
iDRAC does not allow duplicate user names for each of the 16 users.
918