Reference Guide

Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
OSD34
Message Unable to continue with BootToPXE - ISO image is attached to the system.
Detailed
Description
Unable to continue with BootToPXE command because the system has an ISO image attached.
Detach the ISO image before continuing with BootToPXE.
Recommended
Response Action
Run the DetachISOImage command and then run BootToPXE.
Category Configuration
SubCategory OSD = OS Deployment
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
OSD35
Message Lifecycle Controller is not enabled.
Detailed
Description
Lifecycle Controller is disabled on the system, so none of the remote operating system
deployment commands will work. Make sure Lifecycle Controller is enabled before running any
command.
Recommended
Response Action
Reboot the system and enable System Services by pressing CTRL+E option when prompted to
do so in the POST. This launches the iDRAC configuration utility where Lifecycle Controller can
be enabled.
Category Configuration
SubCategory OSD = OS Deployment
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
566