Reference Guide

Detailed
Description
The SD card device sensor of the type identified in the messaage has failed. The current status
of the SD card is also displayed.
Recommended
Response Action
Reinsert the SD card or try a different SD card and retry the operation. If the issue persists, do
one of the following to resolve the error: 1) If the SD card sensor is installed on the internal SD
module, replace the module. 2) If the SD card sensor is embedded on the system board,
replace the system board. . For more information, contact your service provider.
Category System Health
SubCategory HWC = Hardware Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. TRUE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
DONTKN
OW
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
HWC8005
Message The SD card device has returned to normal state. SD card location:
arg1 , SD card device
type: arg2 , SD card state: arg3 .
Arguments
•
arg1 =
location
•
arg2 =
type
•
arg3 =
state
Detailed
Description
The SD card device has returned to a normal state. The SD card type and the current status of
the SD card is also displayed.
Recommended
Response Action
No response action is required.
Category System Health
SubCategory HWC = Hardware Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. TRUE
412