Reference Guide

Initial Default. TRUE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
DONTKN
OW
FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
DIAG0150
Message Hard Drive - No Hard Drive detected, or disk controller not supported.
Detailed
Description
Recommended
Response Action
Hard drives on desktops should be found if connected to the chipset disk controller but
PERC/SCU/SAS Adapters are not supported by legacy ePSA so if the hard drive is connected to
these controllers this message is just a warning. If the system has a hard disk connected to the
System Board chipset disk controller, power down the system and check the signal and power
connections to it. Rerun the diagnostic.If no error occurs then it was a cable or connector
issue.
Category Storage
SubCategory DIAG = Diagnostic
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. TRUE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
DONTKN
OW
FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
DIAG0151
Message Hard Drive
arg1 - S/N arg2 , incorrect status = arg3 \n arg4 .
Arguments
• arg1 = Drive Location
•
arg2 =
Serial Number
•
arg3 =
80000000000000??
•
arg4 =
Error Reason
Detailed
Description
Recommended
Response Action
SMART Predictive Failure indicates the hard drive has failed SMART and maybe nearing the
end of its life. Other types of <Error Reason> in this category may indicate an intermittent or
firmware problem, rerun the test again. Desktops, servers: Check the hard disk drive cables
289