Reference Guide

DIAG0145
Message Hard Drive
arg1 - S/N arg2 , self test did not complete.
Arguments
•
arg1 =
Drive Location
•
arg2 =
Serial Number
Detailed
Description
Recommended
Response Action
Desktops and Servers: Power down the system and check the signal and power connections to
the hard drive. Rerun the diagnostic.If no error occurs then it was a cable or connector issue.
Category Storage
SubCategory DIAG = Diagnostic
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. TRUE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
DONTKN
OW
FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
DIAG0147
Message Optical Drive
arg1 - Self test: arg2 .
Arguments
•
arg1 =
Nth Drive
•
arg2 =
Error Reason
Detailed
Description
Recommended
Response Action
This typically is a user error since these drives can be disconnected from the system. If
disconnected, reconnect the optical drive to system board. Check BIOS setup to make sure the
SATA port the drive is connected and has not been disabled. Rerun the diagnostic. If errors
persist the optical drive is defective.
Category Storage
SubCategory DIAG = Diagnostic
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
288