Reference Guide

UEFI0015
Message Lifecycle Controller (LC) firmware was not accessible and is therefore in Recovery mode.
Detailed
Description
The BIOS is unable to access the Lifecycle Controller firmware. No Lifecycle Controller
functionality is available while in Recovery Mode.
Recommended
Response Action
Perform the following actions: 1)Reboot the system. 2) Press F2 during boot to enter System
Setup. 3) Select iDRAC Settings then Lifecycle Controller. 4) Change Lifecycle Controller back
to Enabled. If subsequent failures occur, press and hold the system ID button down for 15
seconds to reset the iDRAC. For more information on how to reset iDRAC, see iDRAC Users
Guide.
Category System Health
SubCategory UEFI = UEFI Event
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
DONTKN
OW
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
UEFI0016
Message Lifecycle Controller (LC) firmware was not accessible and is therefore in Recovery mode.
Detailed
Description
Unable to find a Lifecycle Controller partition. No Lifecycle Controller functionality is available
while in Recovery Mode.
Recommended
Response Action
Perform the following actions: 1)Reboot the system. 2) Press F2 during boot to enter System
Setup. 3) Select iDRAC Settings then Lifecycle Controller. 4) Change Lifecycle Controller back
to Enabled. If subsequent failures occur, press and hold the system ID button down for 15
seconds to reset the iDRAC. For more information on how to reset iDRAC, see iDRAC Users
Guide.
Category System Health
SubCategory UEFI = UEFI Event
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
1328