Reference Guide

CTL49
Message The NVRAM has corrupted data on
arg1 .
Arguments
–
arg1 =
Controller name
Detailed Description The NVRAM has corrupted data. This may occur after a power surge, a battery
failure, or for other reasons. The controller is reinitializing the NVRAM.
Recommended Response
Action
No response action is required as the controller is taking the required corrective
action. However, If this message is generated often (such as during each reboot),
then replace the controller.
Category Storage
SubCategory CTL = Storage Contr
Severity Severity 2 (Warning)
Trap/EventID 4330
LCD Message No LCD message display defined.
Initial Default. SNMP Alert
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE FALSE TRUE FALSE FALSE FALSE FALSE
CTL5
Message Bad block replacement error on
arg1 .
Arguments
–
arg1 =
Controller name
Detailed Description A portion of a physical disk is damaged. See Receive a "Bad Block" Alert with
"Replacement," "Sense," or "Medium" Error for more information.
Recommended Response Action See Receive a "Bad Block" Alert with "Replacement," "Sense," or "Medium" Error for
more information.
Category Storage
SubCategory CTL = Storage Contr
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default. None
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
217