Users Guide

110 Installing Managed System Software on Supported Linux Operating Systems

If you burned the ISO file to a CD, insert it in the optical drive and run

$ mount /dev/cdrom /mnt

Install the supplemental pack.

$ cd /mnt

$ ./install.sh

NOTE: If a previous version of OpenMange is already present, then the command

to upgrade it to the 6.4 version is ./install.sh .

After the installation or upgrade of OpenManage, execute the post-

installation configuration script of Remote Enablement feature by

$ cd /opt/dell/srvadmin/etc

$ ./autoconf_cim_component.sh -p 5986

When the installation is complete, unmount the ISO file or CD.

$ cd ..

$ umount /mnt

CAUTION: Removal of the Dell OpenManage Supplemental Pack or any Dell

OpenManage RPMs is not supported by Dell or Citrix and it is not recommended.

Manual removal of any RPM leaves the system in an inconsistent state which

could make any potential issue debugging effort difficult or impossible. A future

Supplemental Pack release supports removal of the Dell OpenManage

Supplemental Pack.

If the XenServer image is upgraded to a newer XenServer update or release,

the Dell OpenManage Supplemental Pack must be re-installed since the new

XenServer image is placed on a different partition than the original. In this

case, follow the same installation instructions as before. However, any Dell

OpenManage configuration settings saved on your server is lost.

See the Citrix XenServer Dell Edition Solution Guide at

support.dell.com/support/edocs/software/Citrix/ for details on using Dell

OpenManage with Citrix XenServer Dell Edition.

NOTE: If you are connecting to a XenServer 5.6 managed node using server

administrator web server, use port 5986 in the format Hostname:Port Number, or IP

address:Port Number.