Users Guide

Dell OpenManage on VMware ESXi 115
vicfg-advcfg.pl --server <ip_address of ESXi host>
--username <user_name> --password <password> --set
1 UserVars.CIMOEMProvidersEnabled
NOTE: The .pl extension is not required if you are using vSphere CLI on Linux.
3 For the changes to take effect without restarting the system, use the
Restart Management Agents option in the Direct Console User Interface
(DCUI) on the local console of the VMware ESXi system.
If the changes are not effective and you cannot connect to the VMware
ESXi host using Server Administrator, restart the VMware ESXi host
system.
Enabling CIM OEM Providers Using vMA (for VMware ESXi 4.0/ESXi 4.1)
1 Log on to the vMA as an administrator and provide the password when
prompted.
2 Execute the following command:
vicfg-advcfg --server <ip_address of ESXi host> --
username <user_name> --password <password> --set 1
UserVars.CIMOEMProvidersEnabled
3
For the changes to take effect without restarting the system, use the
Restart Management Agents option in the Direct Console User Interface
(DCUI) on the local console of the VMware ESXi system.
If the changes are not effective and you cannot connect to the VMware
ESXi host using Server Administrator, restart the VMware ESXi host
system.
Configuring the SNMP Agent on Systems Running
VMware ESXi 4/ESXi 4.1
Server Administrator generates SNMP traps in response to changes in the
status of sensors and other monitored parameters.You must configure one or
more trap destinations on the system running Server Administrator to send
SNMP traps to a management station.