Users Guide

190 Using Microsoft Active Directory
10 If DRAC 4 NIC DHCP is enabled, place a check next to Use DHCP to
obtain DNS server address
. If you want to input a DNS server IP address
manually, remove the check next to
Use DHCP to obtain DNS server
address
and input your primary and alternate DNS Server IP addresses.
11 Click Apply to complete the DRAC 4 Active Directory feature
configuration.
Configuring the DRAC 5 Using the Web-Based Interface
1 Open a supported Web browser window.
2 Log in to the DRAC 5 Web-based interface.
3 Expand the System tree and click Remote Access .
4 Click the Configuration tab and select Active Directory .
5 In the Active Directory Main Menu page, select Configure Active
Directory
and click Next .
6 Select the Enable Active Directory check box.
7 Ty pe t h e DRAC 5 Name . This name must be the same as the common
name of the RAC object you created in your Domain Controller (see
"Installing the Dell Extension to the Active Directory Users and
Computers Snap-In").
8 Ty pe t h e Root Domain Name . The Root Domain Name is the fully
qualified root domain name for the forest.
9 Ty pe t h e DRAC Domain Name (for example, drac5.com). Do not use the
NetBIOS name. The
DRAC Domain Name is the fully qualified domain
name of the sub-domain where the RAC Device Object is located.
10 Type the Timeout time in seconds.
11 Click Apply to save the Active Directory settings.
12 Click Go Back To Active Directory Main Menu .