Users Guide

92 Installing Managed System Software on Red Hat
®
Enterprise Linux Operating Systems
5 Run the srvadmin-install.sh shell script as shown below, which performs a silent and unattended
express installation. All of the components, including any applicable remote access controller
(DRAC III or DRAC 4) software components, will be installed.
sh srvadmin-install.sh --express
or
sh srvadmin-install.sh -x
NOTE: If a remote access controller is not present, then RAC software components will not be installed.
Server Administrator services do not start automatically.
6 Start the Server Administrator services after the installation using the srvadmin-services.sh script by
using the
sh srvadmin-services start command.
Custom Install
Managed system software provides two custom installation paths. One is RPM-based, with
pre-configured custom directories, and the other is shell script-based.
Using Pre-configured Custom Directories to Perform the Custom Installation
See Table 7-1 for details about using the RPMs to perform a custom installation using pre-configured
custom directories.
Table 7-1. Custom Installation Using Pre-Configured Directories
Directory Details
To facilitate an RPM-based custom installation,
add the RPMs from the following directory:
/srvadmin/linux/custom/srvadmin-base
Contains base Server
Administrator with command
line interface
Then customize the installation by adding the
RPMs from the following directories:
/srvadmin/linux/custom/add-diagnostics
Diagnostics component
packages
/srvadmin/linux/custom/add-RAC3
DRAC III component
packages
/srvadmin/linux/custom/add-RAC4
DRAC 4 component packages
/srvadmin/linux/custom/add-storageservices
Storage Management
component packages
/srvadmin/linux/custom/add-webserver
Web Server component
packages