Release Notes
command=clearmemfailures. The binary dcicfg, needed to launch the command from a shell command, is included in
the OpenManage Server Administrator (OMSA) suite.
● JIT-148035: On Server Administrator, vFlash is not supported from YX5X generation of servers and above.
● JIT-148988: While logging to the Server Administrator GUI, the login may fail if the password contains the non-ASCII
characters for example: Euro symbol €.
● JIT-139048: The Command Log Size value if modified on Server Administrator Preferences page as Local user and then
logging into the same server via Server Administrator Managed System Login. The changes of the attribute are not reflected
in the Preferences page of Server Administrator Managed System Login.
● JIT-158772: On a de-branded Server, if Server Administrator services are not running, the omreport command line utility
and the Server Administrator GUI defaults to display the Server as a Dell EMC Server. This occurs as the server is unable to
access the de-brand settings of the Server Administrator.
● JIT-162678 & JIT-163534: The memory event on the Server Administrator alert log displays the corresponding alert more
than once occasionally.
● JIT-161422 : On generation of the certificate on the Server Administrator GUI, keysigning algorithm preference gets
disabled. If an attempt is made through the Server Administrator CLI to configure a different keysigning algorithm, a return
code of success is displayed but will not reconfigure. The keysigning algorithm remains the same as the one with which the
certificate was generated.
● JIT-159129: A time delay of 30 seconds is expected in the output of omreport about command in CLI or About page in GUI
of OMSA. This occurs if there is only intranet available with static IP configuration and no internet available on ethernet
ports.
● JIT-158074: Devices connected through SlimLine may not enumerate in Server Administrator System Components (FRU)
page. These devices will still enumerate in Slots page if they are on a system slot.
Issues for Remote Access
NOTE:
The Remote Access Service is supported on YX1X generation of PowerEdge servers only. The following subsections
list the currently known issues regarding implementation and operation of your RAC and the Remote Access Service in
Server Administrator.
Issues of Server Administrator on all Operating Systems
● The Server Administrator user interface and commands related to local authentication enable are not applicable for RAC
firmware 3.20. The Active Directory authentication feature replaces the local operating system authentication feature in
this version of firmware. Due to this change, the following commands return errors:
○ racadm localauthenable
○ omconfig rac authentication
NOTE: The following packages will be deprecated from DellEMC Server Administrator release 9.1.0:
1. Srvadmin-racadm4.
2. Srvadmin-racadm5.
● Due to fluctuations in the watchdog timer, the Last Crash Screen may not be captured when the Automatic System
Recovery is set to a value of less than 30 seconds. To ensure the correct functioning of the Last Crash Screen feature, set
the System Reset Timer to at least 30 seconds.
● DF132894: The cfgDNSServer1 and cfgDNSServer2 properties of group cfgLanNetworking may be set to identical values
while swapping addresses. Some performance may be lost temporarily during the swapping. The cfgLanNetworking group is
configured using theracadm config command.
● The remote access controller uses FTP protocol to perform some of the Server Administrator commands. If a firewall is
installed in the system, it may cause these commands to fail.
The following Server Administrator CLI commands use FTP protocol to communicate with the RAC:
○ omconfig rac uploadcert
○ omconfig rac generatecert
The following racadm commands use FTP protocol to communicate with the RAC:
○ racadm sslcertupload
○ racadm sslcsrgen
11