CLI Guide

Omconfig global threshold for remaining rated write endurance
Table 214. Omconfig Global threshold for remaining rated write endurance
Description Sets the threshold value for Remaining Rated Write Endurance (RRWE) SMART attribute for
SSDs. When the remaining rate write endurance threshold drops below the configured threshold,
an alert is logged. For more information about Global Threshold for Remaining Rated Write
Endurance, see the Dell EMC OpenManage Online Help.
Syntax
omconfig storage globalinfo
action=setremainingratedwriteendurancethreshold type=<sassata|
pciessd> threshold=<1-100>
Example to Settings supported for different threshold values for SAS, SATA and PCIe SSDs. The omconfig
command syntax for Threshold RRWE value is set between 0 to 100.
NOTE: The RRWE SMART attribute is not supported for SSDs connected to software RAID
Controllers.
Example
omconfig storage globalinfo
action=setremainingratedwriteendurancethreshold type=sassata
threshold=0.
Omconfig Connector Commands
The following table displays the omconfig command syntax required to execute connector tasks.
Table 215. omconfig Connector Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs
omconfig storage
connector
action=rescan controller=id connector=id
Omconfig Rescan Connector
Table 216. Omconfig Rescan Connector
Description Rescans a controller connector. This command rescans all connectors on the controller and is
therefore similar to performing a controller rescan.
NOTE: This command is not supported on SAS controllers.
Syntax omconfig storage connector action=rescan controller=id connector=id,
where id is the controller ID and the connector ID as reported by the omreport command. To
obtain these values, type omreport storage controller to display the controller IDs and
then type omreport storage connector controller=ID to display the IDs for the
connectors attached to the controller.
Example to Rescan connector 2 on controller 1.
Example
omconfig storage connector action=rescan controller=1 connector=2
Omconfig cachecade commands
The following table displays the omconfig command syntax required to execute cachecade tasks.
184
Omconfig storage commands