CLI Guide

Omconfig Import Secure Foreign Configuration
Table 181. Omconfig Import Secure Foreign Configuration
Description Unlocks the encrypted Local Key Management (LKM) foreign configuration drives.
Syntax
omconfig storage controller action= importsecureforeignconfig controller=id
passphrase=<passphrase string for the foreign configuration>, where id is the
controller ID as reported by the omreport storage controller command.
Example to Unlock the ecncrypted LKM configuration drives on controller 1
Example
omconfig storage controller action= importsecureforeignconfig controller=1
passphrase= Dell_123
Omconfig Import Foreign Configuration
Table 182. Omconfig Import Foreign Configuration
Description Imports all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= importforeignconfig controller=id, where id is
the controller ID as reported by the omreport storage controller command.
NOTE: This command is supported only in firmware version 5.0.x.
Example to Import foreign configurations on controller 1.
Example
omconfig storage controller action= importforeignconfig controller=1
Omconfig Import Or Recover Foreign Configuration
Table 183. Omconfig Import Or Recover Foreign Configuration
Description Imports and recovers all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= importrecoverforeignconfig controller=id,
where id is the controller ID as reported by the omreport storage controller command.
NOTE: This command is supported on firmware version 5.1.1 and later.
Example to Import foreign configurations on controller 1.
Example
omconfig storage controller action= importrecoverforeignconfig controller=1
Omconfig Clear Foreign Configuration
Table 184. Omconfig Clear Foreign Configuration
Description Clears or deletes all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= clearforeignconfig controller=id, where id is
the controller ID as reported by the omreport storage controller command.
NOTE: This command is supported only in firmware version 5.0.x.
Omconfig storage commands 173