CLI Guide

or
omconfig servermodule alertlog action=clear
NOTE: Entering an invalid RAC user name may prevent the command log from displaying. Clearing the command log
resolves this condition.
To clear the contents of the command log, type:
omconfig system cmdlog action=clear
or
omconfig servermodule cmdlog action=clear
To clear the contents of the ESM log, type:
omconfig system esmlog action=clear
or
omconfig servermodule esmlog action=clear
NOTE: For more information about alert messages, see the OpenManage Server Administrator Messages Reference
Guide at dell.com/support/manuals.
Omconfig system pedestinations or omconfig
servermodule pedestinations
Use the omconfig system pedestinations or omconfig servermodule pedestinations command to set IP addresses
for alert destinations.
The following table displays the valid parameters for the command.
NOTE:
You can either specify the index and IP address as parameters together or you can set only the community string
as a parameter.
NOTE: Index 1 to 4 accepts an IPv4 address and index 5 to 8 accepts an IPv6 address. On YX2X generation of
PowerEdge systems with iDRAC7 specific versions, the index can accept IPv4, IPv6, or FQDN.
Table 68. Valid Parameters Of Omconfig System Pedestinations Or Omconfig Servermodule Pedestinations
name=Value Pair Description
destenable=true | false
true: Enables an individual platform event filter destination after a valid IP address has been set.
false: Disables an individual platform event filter.
index=number Sets the index for the destination.
ipaddress=<ipv4 address | ipv6
address | fqdn>
Sets the IP address for the destination.
NOTE: On YX2X generation of PowerEdge systems with iDRAC7 specific versions,
ipaddress can also be a Fully Qualified Domain Name (FQDN).
communitystr=text Sets the text string that acts as a password and is used to authenticate SNMP messages sent
between the BMC and the destination management station.
104 Omconfig Managing Components Using The Instrumentation Service