Install Guide

Conguring SNMP Agents
The systems management software supports the SNMP systems management standard on all supported operating systems. The SNMP
support may or may not be installed depending on the operating system and how the operating system was installed. An installed supported
systems management protocol standard, such as SNMP, is required before installing the systems management software.
Congure the SNMP agent to change the community name, enable set operations, and send traps to a management station. To congure
the SNMP agent for proper interaction with management applications, perform the procedures that are described in the Dell EMC
OpenManage Server Administrator User’s Guide.
Related Links:
• Installation Requirements
• Supported Systems Management Protocol Standards
Remote Enablement Requirements
The Remote Enablement feature is supported on:
• Red Hat Enterprise Linux
• SUSE Enterprise Linux
• VMware vSphere (ESXi)
Dependent RPMs For Remote Enablement
If you choose to install the Remote Enablement feature, you have to install certain dependent RPMs and congure these RPMs before
installing the feature. Install the following RPMs:
• libcmpiCppImpl0
• libwsman1 (RHEL)
• libwsman3 (SLES15)
• openwsman-server
• sblim-sfcb
• sblim-sfcc
NOTE
: Make sure that Pegasus RPMs are uninstalled.
Post Installation Conguration For Remote Enablement
This section details the steps to congure the dependent RPMs if you have installed the Remote Enablement feature.
The post installation conguration script is available at /opt/dell/srvadmin/etc/ on the server le system.
After installing all the dependent RPMs and the Remote Enablement feature, run the autoconf_cim_component.sh script.
Before running the autoconf_cim_component.sh script, ensure that Systems Management is installed.
Run the following command to congure sfcb and openwsman as per the default congurations: ./ autoconf_cim_component.sh
NOTE
: To congure openwsman on the managed node to run on a dierent port, use the -p < port > option with
autoconf_cim_component.sh. This is optional and by default the openwsman is congured to run on port 443.
12 Preinstallation Setup