Connectivity Guide

Description Line Item Explanation
Memory device bank location: Bank_1
Memory device location:
<Device name in chassis>
Species the location of the memory module in the chassis, for example:
Memory device location: DIMM_A
Number of devices required
for full redundancy:
<Number>
Species the number of power supply or cooling devices required to achieve full redundancy, for
example:
Number of devices required for full redundancy: 4
Peak value (in Watts):
<Reading>
Species the peak value in Watts, for example:
Peak value (in Watts): 125
Possible memory module
event cause: <list of
causes>
Species a list of possible causes for the memory module event, for example:
Possible memory module event cause: Single bit warning error rate
exceeded
Single bit error logging disabled
Power Supply type: <type of
power supply>
Species the type of power supply, for example:
Power Supply type: VRM
Pre-failure state was:
<State>
Species the status of the previous memory message, for example:
Pre-failure state was: Failed
Previous redundancy state
was: <State>
Species the status of the previous redundancy message, for example:
Previous redundancy state was: Lost
Previous state was: <State>
Species the previous state of the sensor, for example:
Previous state was: OK (Normal)
Processor sensor status:
<status>
Species the status of the processor sensor, for example:
Processor sensor status: Configuration error
Redundancy unit:
<Redundancy location in
chassis>
Species the location of the redundant power supply or cooling unit in the chassis, for example:
Redundancy unit: Fan Enclosure
SD card device type: <Type
of SD card device>
Species the type of SD card device, for example:
SD card device type: Hypervisor
SD card state: <State of SD
card>
Species the state of the SD card, for example:
SD card state: Present, Failed
Sensor location: <Location
in chassis>
Species the location of the sensor in the specied chassis, for example:
Sensor location: CPU1
Temperature sensor value
(in degrees Celsius):
<Reading>
Species the temperature in degrees Celsius, for example:
Temperature sensor value (in degrees Celsius): 30
Voltage sensor value (in
Volts): <Reading>
Species the voltage sensor value in volts, for example:
Voltage sensor value: 1.693
SNMP Traps 465