CLI Guide

NOTE: Not all BIOS setup options are available on every system.
NOTE: When CSIOR (Collect System Inventory on Restart) is disabled, you cannot congure the BIOS settings using omcong
command.
BIOS setup settings on systems prior to PowerEdge 12G systems
The following table displays the name=value pairs that you can use with omcong chassis biossetup or omcong mainsystem biossetup
command on systems prior to PowerEdge 12G systems.
Table 46. BIOS Setup Settings on systems prior to PowerEdge 12G systems
name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=acpwrrecovery setting=o | last| on
• o: System is turned o.
• last: System returns to the previous
state.
• on: System is turned on.
delay=random | immediate | timedelay
<value>
• random: System is turned on with
random delay.
• immediate: System returns to previous
state immediately.
• timedelay < value >: System is turned on
based on the user specied time delay.
attribute=bezel setting=enabled | disabled
• enabled: Enables the bezel removal
intrusion check during system boot.
• disabled: Disables the bezel removal
intrusion check during system boot.
attribute=bootsequence setting=disketterst | hdonly | devicelist |
cdromrst | opticaldrive
Instructs the BIOS which device is used to
boot the system, and the order in which the
boot routine checks each device.
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot congure this BIOS
setup setting.
attribute=bootmode setting=ue | bios
• ue: Enables the system to boot to
operating systems that support Unied
Extensible Firmware Interface (UEFI).
• bios: Enables the system to boot to
operating systems that do not support
UEFI.
attribute=bootorder sequence=aliasname1, aliasname2,.....
aliasnameN
Congures the boot sequence according to
the set aliasnames. To view the set alias
names, run the command omreport
chassis biossetup
attribute=bootorder
Omcong Managing Components Using The Instrumentation Service 61