CLI Guide

Table 22. Speedunit detail

Memory Device Information

Health : Ok

Status : Ok

Device Name : A2

Size : 4096 MB

Type : DDR4 Synchronous Registered (Buffered)

Speed : 2133 MT/s

Rank : Single

Failures : None

NOTE: To maintain consistency across the commands, the output format of this command and the subsequent command levels

has changed. Change the user scripts as applicable.

Omreport chassis nics or omreport mainsystem nics

Use the omreport chassis nics or omreport mainsystem nics command to view NIC and Team interface details. On XenServer, the

command displays all the installed NICs, regardless of driver installation.

NOTE

: The order in which devices are detected is not guaranteed to match the physical port ordering of the device.

To view NIC properties, type:

omreport chassis nics index=n

The index parameter is optional. If you do not specify the index, Server Administrator displays properties of all NICs on the system and the

values for the following elds: Index (NIC card number), Interface Name, Vendor, Description, Connection Status, and Slot.

If you specify the index, Server Administrator displays properties for a specic NIC and the values for the following elds: Physical

Interface, Interface, IPv4 Addresses, IPv6 Addresses, Physical Interface Receive Statistics, Physical Interface Transmit Statistics, Interface

Receive Statistics, and Interface Transmit Statistics.

NOTE

: The Fibre Channel over Ethernet (FCoE) and iSCSI over Ethernet (iSCSI Ooad Engine) features of Converged Network

Adapter (CNA) cards are not supported on VMware ESX and VMware ESXi systems.

To view Team interface properties, type:

omreport chassis nics config=team index=n

omreport mainsystem nics config=team index=n

NOTE

: This command is applicable only if Team interface is congured in the system. Team interface is congured using NIC

vendor tools, such as Broadcom.

NOTE: On systems running Linux operating systems with kernel versions earlier than 3.10, Team Interface speed is not displayed.

The index parameter is optional. If you do not specify the index, Server Administrator displays details of all the Team interfaces on the

system and the values for the following elds: Index (NIC card number), Interface Name, Vendor, Description, and Redundancy Status.

omreport Viewing System Status Using The Instrumentation Service