CLI Guide

Example to Set the thresholds for all temperature probes residing in enclosure 3 attached to connector 2 on controller
1, to 10 and 40 degree Celsius.
Example for SAS controllers
omconfig storage enclosure action=setalltempprobes controller=1
enclosure=2:3 minwarn=10 maxwarn=40
Omcong Reset All Temperature Probe Thresholds
Table 204. Omcong Reset All Temperature Probe Thresholds
Description Resets the minimum and maximum warning temperature thresholds back to their default value for all
temperature probes in the enclosure.
NOTE: This command is not supported on SCSI RAID controllers.
Syntax
omconfig storage enclosure action=resetalltempprobes controller=id
enclosure=<ENCLOSUREID>, where id is the controller ID. The <ENCLOSUREID> variable species
the enclosure.
In this syntax, n is a user-specied alphanumeric string.
Example to Reset the thresholds for all temperature probes in enclosure 3 attached to connector 2 on controller 1.
Example for SAS controllers
omconfig storage enclosure action= resetalltempprobes controller=1
enclosure=2:3
Omcong Blink
Table 205.
omcong Blink
Description Blinks the light-emitting diodes (LEDs) on the enclosure.
Syntax
omconfig storage enclosure action=blink controller=id
enclosure=<ENCLOSUREID>, where id is the controller ID. The <ENCLOSUREID> variable species
the enclosure.
Example to Blink the LEDs for enclosure 3 attached to connector 2 on controller 1.
Example for SAS controllers
omconfig storage enclosure action=blink controller=1 enclosure=2:3
Example for SCSI, SATA,
and ATA controllers
omconfig storage enclosure action=blink controller=1 enclosure=2
Omcong Battery Commands
The following table displays the omcong command syntax required to execute battery tasks.
Omcong
storage commands 183