CLI Guide

NOTE: If a virtual disk, hotspare, or encryption key is enabled on the controller, the controller mode cannot
be changed to HBA. Reboot the system for the change to take eect.
NOTE: If a virtual disk, hotspare or NON-RAID disk is present, the controller mode cannot be changed to
RAID from Enhanced HBA mode.
Example to Set the controller mode to HBA.
Example
omconfig storage controller action=setcontrollermode controller=1 mode=hba
Omcong autocongure RAID0
Table 187. Omcong autocongure RAID-0
Description Automatically congures RAID–0 with all disks that are in ready state.
Syntax omconfig storage controller action=autoconfigureRAID0 controller=id , where id is the
controller ID as reported by the omreport storage controller command.
Example to Automatically congure RAID–0 with other disks.
Example
omconfig storage controller action=autoconfigureRAID0 controller=1
Omcong Set Patrol Read Mode
Table 188.
Omcong Set Patrol Read Mode
Description Sets the patrol read mode for the controller.
Syntax
omconfig storage controller action= setpatrolreadmode controller=id mode= manual|
auto|disable, where id is the controller ID as reported by the omreport storage controller command.
Example to Sets the patrol read on controller 1 to manual mode
Example
omconfig storage controller action= setpatrolreadmode controller=1 mode=manual
Omcong Start Patrol Read
Table 189.
Omcong Start Patrol Read
Description Starts the patrol read task on the controller.
Syntax omconfig storage controller action=startpatrolread controller=id, where id is the controller
ID as reported by the omreport storage controller command.
Example to Start the patrol read task on controller 1.
Example
omconfig storage controller action=startpatrolread controller=1
Omcong storage commands 177