CLI Guide

Omcong Clear Foreign Conguration
Table 184. Omcong Clear Foreign Conguration
Description Clears or deletes all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= clearforeignconfig controller=id, where id is the
controller ID as reported by the omreport storage controller command.
NOTE: This command is supported only in rmware version 5.0.x.
Example to Clear foreign congurations on controller 1.
Example
omconfig storage controller action= clearforeignconfig controller=1
Omcong physical disk power management
Table 185. Omcong physical disk power management
Description Manages the power of physical disks in a controller by spinning down hot spares, congured drives, and uncongured
drives.
Syntax
omconfig storage controller action= setpdiskpwrmanagement
spindownunconfigureddrives= <enabled | disabled> spindownhotspares=<enabled |
disabled> spindownconfigureddrives=<enabled | disabled> idlec=<enabled | disabled>
spindowntimeinterval=<30 to 1440>(minutes) spinupstarttime=<HH:MM:AM/PM>
spinuptimeinterval= <1 to 24>(hours), where id is the controller ID as reported by the omreport storage
controller command.
NOTE: On PERC 7 controllers, only spindownunconfigureddrives, spindownhotspares, and
spindowntimeinterval parameters are supported.
NOTE: You can specify spinupstarttime and spinuptimeinterval only when you set
spindownconfigureddrives=enabled.
Example to Spin down drives that are not congured or hot spares that are unattended for 30 minutes
Example
omconfig storage controller action= setpdiskpwrmanagement
spindownunconfigureddrives= enabled spindownhotspares=enabled
spindowntimeinterval=30 controller=1
Omcong set controller mode
Table 186.
Omcong set controller mode
Description Sets the mode of the controller to RAID, HBA or Enhanced HBA.
Syntax
omconfig storage controller action=setcontrollermode controller=id mode=raid|hba|
enhancedhba, where id is the controller ID as reported by the omreport storage controller command.
176 Omcong storage commands