Manualshelf

CLI Guide

ManualsBrandsDell ManualsActive System ManagerOpenManage Server Administrator Version 9.3
161162163164165166167168169170
omcong Test Controller Alarm
Table 156. omcong Test Controller Alarm
Description Tests the functionality of the controller alarm. The alarm sounds for about two seconds. For more
information, see Dell EMC OpenManage Online Help.
Syntax omconfig storage controller action=testalarm controller=id , where id is the
controller ID as reported by the omreport storage controller command.
Example to Test the alarm on controller 1.
Example
omconfig storage controller action=testalarm controller=1
Omcong Reset Controller Conguration
Table 157. Omcong Reset Controller Conguration
Description Resets the controller conguration.
CAUTION: Resetting a conguration permanently destroys all data on all virtual
disks attached to the controller. System or boot partition residing on these virtual
disks is destroyed. You may receive a warning message if this command results in
deleting the system or boot partition. However, this warning message is not
generated always. Ensure that you do not delete the system or boot partition or
other vital data when using this command.
Syntax omconfig storage controller action=resetconfig controller=id,
where id is the controller ID as reported by the omreport storage controller command.
In some circumstances, you may receive a warning message if this command deletes the
system or boot partition. You can override this warning by using the force=yes parameter. In
this case, the syntax is as follows:
omconfig storage controller action=resetconfig
controller=id force=yes
Example to Reset the conguration on controller 1.
Example
omconfig storage controller action=resetconfig controller=1
omcong Create Virtual Disk
The Dell EMC OpenManage Online Help provides additional information about creating virtual disks.
The omcong syntax for creating a virtual disk has several parameters. You must specify the following parameters:
• Controller (controller=id)
• RAID level (raid=<c| r0 | r1 | r1c | r5 | r6 | r10 | r50 | r60>
• Size (size=<number | max | min>)>
Physical disk is specied as either:
164
Omcong storage commands