CLI Guide

Example
omconfig storage vdisk action=cancelbginitialize controller=1 vdisk=4
Omcong Assign Dedicated Hot Spare
Table 143. omcong Assign Dedicated Hot Spare
Description Assigns one or more physical disks to a virtual disk as a dedicated hot spare.
Syntax
omconfig storage vdisk action=assigndedicatedhotspare controller=id
vdisk=id pdisk=<PDISKID> assign=yes, where id is the controller ID and virtual disk ID as
reported by the omreport command. The <PDISK>variable species the physical disk.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks and
physical disks attached to the controller.
Example to Assign physical disk 3 on connector 0 of controller 1 as a dedicated hot spare to virtual disk 4. On a Serial
Attached SCSI (SAS) controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA,
and ATA controllers
omconfig storage vdisk action=assigndedicatedhotspare controller=1
vdisk=4 pdisk=0:3 assign=yes
Example for SAS controllers
omconfig storage vdisk action=assigndedicatedhotspare controller=1
vdisk=4 pdisk=0:2:3 assign=yes
Omcong Delete Virtual Disk
Table 144.
omcong Delete Virtual Disk
Description Deletes a virtual disk.
CAUTION: Deleting a virtual disk destroys all information including le systems and volumes
residing on the virtual disk. You may receive a warning message if you attempt to delete the
system or boot partition. However, this warning message is not generated always. Ensure that
you do not delete the system or boot partition or other vital data when using this command.
Syntax omconfig storage vdisk action=deletevdisk controller=id vdisk=id, where id is
the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
NOTE: In some circumstances, you may receive a warning message if this command deletes
the system or boot partition. You can override this warning by using the force=yes parameter.
In this case, the syntax is as follows:
omconfig storage vdisk action=deletevdisk controller=id vdisk=id
force=yes
Example to Delete virtual disk 4 on controller 1
Example
omconfig storage vdisk action=deletevdisk controller=1 vdisk=4
Omcong storage commands 157