CLI Guide
CAUTION: You may receive a warning message if you attempt to delete the system or boot
partition. However, this warning message is not generated always. Ensure that you do not
delete the system or boot partition or other vital data when using this command.
Syntax omconfig storage vdisk action=slowinit controller=id vdisk=id, where id is the
controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
NOTE: In some circumstances, you may receive a warning message if this command deletes
the system or boot partition. You can override this warning by using the force=yes parameter.
In this case, the syntax is as follows:
omconfig storage vdisk action=slowinit controller=id vdisk=id
force=yes
Example to Slow initialize virtual disk 4 on controller 1.
Example
omconfig storage vdisk action=slowinit controller=1 vdisk=4
Omcong cancel initialize virtual disk
Table 141. omcong cancel initialize virtual disk
Description Cancels the initialization of a virtual disk.
Syntax omconfig storage vdisk action=cancelinitialize controller=id vdisk=id,
where id is the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
Example to Cancels the initialization of virtual disk 4 on controller 1.
Example
omconfig storage vdisk action=cancelinitialize controller=id vdisk=id
Omcong cancel background initialize
Table 142.
omcong cancel background initialize
Description Cancels the background initialization process on a virtual disk.
Syntax omconfig storage vdisk action=cancelbginitialize controller=id vdisk=id,
where id is the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
Example to Cancel background initialization on virtual disk 4 on controller 1.
156 Omcong storage commands