CLI Guide
Omcong Initialize Virtual Disk
Table 138. omcong Initialize Virtual Disk
Description
Initializes a virtual disk.
Syntax omconfig storage vdisk action=initialize controller=id vdisk=id, where id is
the controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
Example to Initialize virtual disk 4 on controller 1
Example
omconfig storage vdisk action=initialize controller=1 vdisk=4
Omcong Fast Initialize Virtual Disk
Table 139. omcong Fast Initialize Virtual Disk
Description Fast initializes a virtual disk.
CAUTION: You may receive a warning message if you attempt to delete the system or boot
partition. However, this warning message is not generated always. Ensure that you do not
delete the system or boot partition or other vital data when using this command.
Syntax omconfig storage vdisk action=fastinit controller=id vdisk=id, where id is the
controller ID and virtual disk ID as reported by the omreport command.
NOTE: To obtain these values, type omreport storage controller to display the controller IDs
and then type omreport storage vdisk controller=ID to display the IDs for the virtual disks
attached to the controller.
NOTE: In some circumstances, you may receive a warning message if this command deletes
the system or boot partition. You can override this warning by using the force=yes parameter.
In this case, the syntax is as follows:
omconfig storage vdisk action=fastinit controller=id vdisk=id
force=yes
Example to Fast initialize virtual disk 4 on controller 1.
Example
omconfig storage vdisk action=fastinit controller=1 vdisk=4
Omcong Slow Initialize Virtualize Disk
Table 140.
Omcong Slow Initialize Virtualize Disk
Description Slow initializes a virtual disk.
Omcong storage commands 155