CLI Guide

Omcong Convert Non-RAID To RAID
Table 129. omcong Convert Non-RAID To RAID
Description
Converts non-RAID to RAID on a physical disk.
Syntax
omconfig storage pdisk
action=convertnonraidtoraid controller=id
pdisk=<PDISKID>, where id is the controller ID. The <PDISKID>
variable species the physical disk.
NOTE: To obtain these values, type omreport storage
controller to display the controller IDs and then type
omreport storage pdisk controller=ID to display the IDs for
the physical disks attached to the controller.
NOTE: To convert multiple non-RAID to RAID on a given
controller, use omcong storage controller
action=convertnonraidtoraid command. For more
information, see omcong Convert Multiple Non-RAID To
RAID.
Example to Convert non-RAID to RAID on physical disk 3 on connector 0 of
controller 1. On a SAS controller, the physical disk resides in
enclosure 2.
Example for SAS controllers
omconfig storage pdisk action=nonraidtoraid
controller=1 pdisk=0:2:3
Omcong Set array disk cache
Table 130.
Omcong Set array disk cache
Description Setting the disk cache policy on the given physical disk.
Syntax
omconfig storage pdisk action=setarraydiskcache controller=id
pdisk=<PDISKID>, where PDISKID=<connector:enclosureID:portID | connector:targetID>.
Example to Set the disk cache policy on the physical disk.
Example
omconfig storage pdisk action=setarraydiskcache controller=0 pdisk=0:2:3
Omcong virtual disk commands
The following table provides the omcong command syntax required to run virtual disk tasks.
CAUTION
: The omcong storage vdisk action=deletevdisk controller=id vdisk=id command deletes a virtual disk. Deleting a
virtual disk destroys all information including le systems and volumes residing on the virtual disk.
Omcong storage commands 151