CLI Guide

Table 106. Omreport Storage Tape Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller number.
For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the specied
connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specied tape drive.
Omreport NVMe adapter
The following table describes the syntax for the omreport nvmeadapter commands.
Table 107. omreport NVMe adapter command
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage nvmeadapter
Displays the properties of the NVMe
adapters.
controller=id, where id is the controller
number. For example, controller=0.
Displays the properties of all the NVMe
adapters on the specied controller.
controller=id, nvmeid=id, where id is the
controller number and the NVMe adapter
respectively. For example, controller=0
nvmeid=1.
Displays the properties of the specied
NVMe adapter on the specied controller.
Omreport storage commands 139