CLI Guide

• Omreport Global Information
• Omreport Connector Status
• Omreport Cachecade Status
• Omreport Storage Tape
• Omreport NVMe adapter
Omreport Physical Disk Status
The following table describes the syntax for the omreport Physical Disk commands.
Table 93. Omreport Physical Disk Commands
Required Command Levels (1, 2, 3) And
name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the controller
number. For example, controller=0
Displays all physical disks attached to the
specied controller.
NOTE: If a physical disk was
replaced by another disk as part of
the replace member operation, the
state of the physical disk is
displayed as Replacing.
vdisk=id, where id is the virtual disk number.
For example, vdisk=1
Displays all physical disks included in the
specied virtual disk on the controller.
cachecade=id where id is the cachecade
number. For example, cachecade=1
Displays all physical disks included in the
specied cachecade on the controller.
connector=id where id is the connector
number. For example, connector=1
Displays all physical disks attached to the
specied connector on the controller.
pdisk=connectorID: targetID | connectorID:
enclosureID: slotID, where connectorID:
targetID is the connector number and the
physical disk number and
connectorID:enclosureID: slotID is the
connector number, enclosure number, and
slot number. For example, pdisk=0:2 or
pdisk=0:1:2
Displays the specied physical disk on the
specied connector on the controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
Table 94. omreport Virtual Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage vdisk Displays property information for all virtual
disks on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all virtual disks on the specied
controller.
controller=id vdisk=id, where id is the
controller number and the virtual disk
number. For example, controller=0 vdisk=1.
Displays the specied virtual disk on the
controller.
Omreport storage commands 133