CLI Guide

In this example, the id in controller=idis the controller number such that controller 1 is specied as controller=1.
Syntax Of Command Elements
The omreport and omcong commands have multiple name=value pairs. These name=value pairs may include required, optional, and
variable parameters. The following table describes the syntax used to indicate these parameters.
Table 91. Syntax For Name=Value Pairs
Syntax Description
controller=id
Indicates the controller ID as reported by the omreport storage controller
command. To obtain these values, type omreport storage controller to
display the controller IDs and then type omreport storage pdisk
controller=id
to display the IDs for the physical disks attached to the
controller.
For example, the controller=id parameter is specied as controller=1.
connector=id
Indicates the connector ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs and
then type omreport storage connector controller=id to display the
IDs for the connectors attached to the controller.
For example, the connector=id parameter is specied as connector=2.
vdisk=id
Indicates the virtual disk ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs and
then type omreport storage vdisk controller=id to display the IDs
for the virtual disks on the controller.
For example, the vdisk=id parameter is specied as vdisk=3.
enclosure=<ENCLOSUREID>
Indicates a particular enclosure by specifying either enclosure=connector or
enclosure=connector:enclosureID.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage enclosure
controller=id
to display the IDs for the enclosures attached to the controller.
pdisk=<PDISKID>
Indicates a particular physical disk by specifying either connector:targetID or
connector:enclosureID:targetID.
To obtain the values for the connector, enclosure, and physical disk (targetID),
type omreport storage controller to display the controller IDs and then
type omreport storage pdisk controller=id to display the IDs for the
physical disks attached to the controller.
battery=id
Indicates the battery ID as reported by the omreport command. To obtain this
value, type omreport storage controller to display the controller IDs and
then type omreport storage battery controller=id to display the ID
for the controller battery.
< >
The caret symbols (< >) enclose variable elements that you must specify.
For example, the name=<string>parameter is specied as name=VirtualDisk1.
[ ]
The bracket symbols ([ ]) indicate optional elements that you can choose whether
or not to specify.
130 Using The Storage Management Service