CLI Guide

Event Name Description
event=tempwarn Sets action or enables or disables alert generation when a temperature probe detects that the
temperature is approaching the maximum high or low limits.
event=removableashmediapresent Sets actions that Server Administrator performs when the system detects a removable ash
media.
event=removableashmediawarn Sets actions that Server Administrator performs when a removable ash media warning is
displayed.
event=removableashmediafail Sets actions that Server Administrator performs when a removable ash media fails.
event=tempfail Sets action or enables or disables alert generation when a temperature probe detects that the
temperature is either too high or low for proper operation.
event=voltfail Sets action or enables or disables alert generation when a voltage probe detects that the
voltage is too low for proper operation.
event=intdualsdcardcritical Sets actions that Server Administrator performs when an internal dual SD card critical event
occurs.
event=intdualsdcardwarn Sets actions that Server Administrator performs when an internal dual SD card warning is
displayed.
event=intdualsdcardabsent Sets actions that Server Administrator performs when an internal dual SD card is not
available.
event=intdualsdcardredunlost Sets actions that Server Administrator performs when the redundancy of an internal dual SD
card is lost.
event=watchdogasr Enables or disables alert generation congured by the ASR when the system has hung or is
not responding.
Omcong system snmptraptest or omcong servermodule
snmptraptest
Use the omcong system snmptraptest or omcong servermodule snmptraptest command to send the snmp test trap to the destination
address if Server Administrator SNMP component is congured in the conguration le.
The following table displays the valid parameters for the command:
Table 71. Parameters For Alert Action Command
Action Description
dest=<ipv4 address | ipv6
address | fqdn>
Send the test trap to the destination IP address.
NOTE: This feature is not supported on VMware ESXi.
Omcong System Events Or Omcong Servermodule Events
Use the omcong system events or omcong servermodule events command to enable and disable SNMP traps for the components on
your system.
NOTE
: Not all event types are present on the system.
Omcong Managing Components Using The Instrumentation Service 113