Users Guide

4 In the Controller Tasks drop-down menu, select Auto Congure RAID0, and then click Execute.
The Auto Congure RAID0 window is displayed. Read the messages displayed on this window before you proceed.
5 Click Conrm to congure the physical disks.
The auto congure operation may take time to complete, depending on the conguration and available physical disks in Ready state.
The Auto Congure RAID0 operation is successful, only if the Alert Log is updated. You can check the Alert Log for more
information.
NOTE: If there are no physical disks in Ready state and you repeat the procedure, the Auto Congure RAID0 operation
automatically ignores your request without displaying any error message. For more information about alerts and their corrective
actions, see the Server Administrator Messages Reference Guide . at dell.com/openmanagemanuals.
System Conguration Lock Down Mode
‘System Conguration Lock Down Mode’ provide a congurable option to the customer so that after it is enabled, any conguration on that
particular system is not permitted with some exceptions. Typical usage of this setting is after the system is provisioned to a certain level
along with the rest of the systems in the domain then enabling this mode reduces the drift the systems usually see during the operation
over a period of time.
When the server is in “System conguration lock down” mode you will not be allowed to initiate any of the conguration operation from
either OMSS GUI or CLI. If this mode is set, you are not allowed to perform most of the operations in OMSS except some of the
enumeration or reporting operations.
You can enable the lock down mode from the iDRAC GUI. For enabling the lock down mode, you have to select the Turn on the System
Lockdown mode option from the More Actions drop-down menu on the iDRAC page. It may take some time for the changes to be
available on the OMSS GUI.
NOTE
: OMSS does not support conguring or setting the lock down mode from either GUI or CLI. For enabling the system
conguration lock down mode, you have to access iDRAC GUI or similar applications.
NOTE: If you restart the data manager/Engine service after setting the system lock down mode on, then the immediate
reection on the OMSS page happens. You might have to refresh the OMSS GUI after the restart, if required.
OMSS CLI: Only the tasks available or supported in the GUI will be available or supported in the OMSS CLI, when the system is in “System
conguration lock down” mode. If you try to run any of the unsupported operation, the following error message is displayed.
‘Error! System Configuration Lockdown mode is turned ON. Configuration actions cannot be
performed in this mode. Operation failed!!!’
Global Tasks Supported When System Conguration Lock
Down Mode Is On
Table 13. Global Tasks Supported When System
Conguration Lock Down Mode Is On
Global
Tasks
Name
PERC
H730P
Adapte
r/Mini
Monoli
thic
PERC
H740P
Adapter
/Mini
Monolit
hic
PERC
H730
Adapter
/Mini
Monolit
hic
PERC
H330
Adapter
/Mini
Monolith
ic
PERC
H840
Adapter
PERC
HBA 330
Adapter/
Mini
PERC
12
GBPS
SAS
HBA
PERC
H730P
MX
PERC
H745P
MX
PERC
HBA 330
MX
PERC
HBA 330
MMZ
PERC
S140
Chec
k
Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes
Controllers 73