Users Guide
• Changing The Controller Mode
• Auto Congure RAID0 Operation
Creating A Virtual Disk
Does my controller support this feature? See Supported Features.
To launch the Create Virtual Disk Express Wizard, select the Create Virtual Disk task.
Enabling The Controller Alarm
Does my controller support this feature? See Supported Features.
To enable the alarm on the controller, select the Enable Alarm task. When enabled, the alarm sounds in the event of a device failure.
Disabling The Controller Alarm
Does my controller support this feature? Supported Features.
Select the Disable Alarm task to disable the alarm on the controller. When disabled, the alarm does not sound in the event of a device
failure.
Turning O The Controller Alarm
Does my controller support this feature? See Supported Features.
Select the Quiet Alarm task to turn o the controller alarm. However, the controller alarm remains enabled for future device failure.
Testing The Controller Alarm
Does my controller support this feature? See Supported Features.
Select the Test Alarm task to test whether the controller alarm is functional. The alarm sounds for about 2 seconds.
Setting The Rebuild Rate
Does my controller support this feature? See Supported Features.
The Set Rebuild Rate task allows you to change the rebuild rate for a controller.
During a rebuild, the complete contents of a physical disk are reconstructed. The rebuild rate, congurable between 0% and 100%,
represents the percentage of the system resources dedicated for rebuilding failed physical disks. At 0%, the rebuild has the lowest priority
for the controller, takes the maximum time to complete, and is the setting with the least impact to system performance. A rebuild rate of
0% does not mean that the rebuild is stopped or paused.
At 100%, the rebuild is the highest priority for the controller, minimizes the rebuild time, and is the setting with the most impact to system
performance.
Controllers
53