Users Guide

◦ Across connectors in the enclosure that are not at the same level but of same size.
◦ Across enclosures connected to the same connector and to a disk of the same size.
◦ Within the enclosure with a physical disk of acceptable size dierence.
◦ Across connectors at the same level of enclosure and of acceptable size dierence.
◦ Across connectors in the enclosure that are not at the same level of the enclosure but with a physical disk of acceptable
size dierence.
If the size dierence is not acceptable, the disk is not mirrored and hence dropped from the span. The number of spans and disks
in the span is recalculated.
NOTE: It is recommended that you use Intelligent Mirroring to create RAID 10 across enclosures for simple and
optimum conguration.
NOTE: After a hard disk being used to create RAID 10 VD with Intelligent Mirroring enabled, the same disk
cannot be used to create another RAID 10 VD with Intelligent Mirroring enabled.
NOTE: To view the redundancy across enclosures achieved through Intelligent Mirroring, click the virtual disk
and view the physical disk IDs in each span, which are from alternate enclosures.
• Select RAID 50 to implement striping across more than one span of physical disks. RAID 50 groups n*s disks as one large virtual
disk with a capacity of s*(n-1) disks, where s is the number of spans and n is the number of disks within each span.
• Select RAID 60 to implement striping across more than one RAID 6 span. RAID 60 groups n*s disks as one large virtual disk with a
capacity of s*(n-2) disks, where s is the number of spans and n is the number of disks within each span. RAID 60 provides
increased data protection and better read performance, but slower write performance.'
8 Select the Bus Protocol.
The possible options are:
• SAS
• SATA
9 Select the Media Type.
The available options are:
• HDD
• SSD
For more information on Bus Protocol and Media Type, see Virtual Disk Properties And Tasks.
10 Click Continue.
The Create Virtual Disk Advanced Wizard (Step 2 of 3) — <Controller Name> page is displayed with the connectors and physical
disks available.
Create Virtual Disk Advanced Wizard Step 2
Depending on the RAID level you selected in the Create Virtual Disk Wizard (Step 1) <Controller Name> page, the Create Virtual Disk
Advanced Wizard (Step 2 of 3) - <Controller Name> page displays the disks and connectors (channels or ports) available for conguring
the virtual disk.
NOTE
: If you are creating an encrypted virtual disk, only the encrypted physical disks are displayed. Else, both encrypted and
unencrypted physical disks are displayed.
The following is an example of what might be displayed:
Connector 0
The Connector section of the page displays the connectors on the controller and the disks attached to each connector. Select the disks
you want to include in the virtual disk. In this example, the controller has a single connector with ve disks.
• Physical disk 0:0:0
• Physical disk 0:1:0
• Physical disk 0:2:0
134
Virtual Disks