Users Guide

Pausing A Check Consistency
Does my controller support this feature? See Supported Features.
The Pause Check Consistency task pauses a check consistency while it is in progress.
NOTE: The Pause Check Consistency task updates the virtual disk State property to Resynching Paused immediately.
The Progress property may continue to increment for up to three seconds. This time delay occurs because the polling
task may take up to three seconds to query the task information and update the display.
Resuming A Check Consistency
Does my controller support this feature? See Supported Features.
The Resume Check Consistency task resumes a check consistency after it has been paused.
Blinking And Unblinking A Virtual Disk
Does my controller support this feature? See Supported Features.
The Blink and Unblink tasks blink or unblink the lights on the physical disks included in the virtual disk.
NOTE:
The blink operation is available only for removable disks.
Renaming A Virtual Disk
Does my controller support this feature? See Supported Features.
The Rename task enables you to change name of the virtual disk.
Canceling A Rebuild
Does my controller support this feature? See Supported Features.
Select the Cancel Rebuild task to cancel a rebuild that is in progress. If you cancel a rebuild, the virtual disk remains in a Degraded state.
The failure of an additional physical disk can cause the virtual disk to fail and may result in data loss. It is recommended that you rebuild the
failed physical disk as soon as possible.
NOTE:
If you cancel the rebuild of a physical disk that is assigned as a hot spare, reinitiate the rebuild on the same
physical disk in order to restore the data. Canceling the rebuild of a physical disk and then assigning another physical
disk as a hot spare does not cause the newly assigned hot spare to rebuild the data. Reinitiate the rebuild on the
physical disk that was the original hot spare.
Changing The Virtual Disk Policy
Does my controller support this feature? See Supported Features.
The Change Policy task enables you to change the read, write, or cache policy of a virtual disk. Changes to the read, write, and cache
policy only apply to the virtual disk that you have selected. This task does not change the policy for all virtual disks on the controller.
Replacing A Member Disk
Does my controller support this feature? See Supported Features.
The Replace Member Disk task allows you to copy data from a physical disk, which is a member of a virtual disk, to another physical disk
by providing the Replace Member Configuration option. You can initiate multiple copies of data from different array groups.
116
Virtual Disks