Install Guide

• VMware vSphere (ESXi)

Dependent RPMs For Remote Enablement

If you choose to install the Remote Enablement feature, you have to install certain dependent RPMs and configure these RPMs before

installing the feature. Install the following RPMs:

• libcmpiCppImpl0

• libwsman1 (RHEL)

• openwsman-server

• sblim-sfcb

• sblim-sfcc

NOTE: Make sure that Pegasus RPMs are uninstalled.

Post Installation Configuration For Remote Enablement

This section details the steps to configure the dependent RPMs if you have installed the Remote Enablement feature.

The post installation configuration script is available at /opt/dell/srvadmin/etc/ on the server file system.

After installing all the dependent RPMs and the Remote Enablement feature, run the autoconf_cim_component.sh script.

Before running the autoconf_cim_component.sh script, ensure that Systems Management is installed.

Run the following command to configure sfcb and openwsman as per the default configurations: ./

autoconf_cim_component.sh

NOTE:

To configure openwsman on the managed node to run on a different port, use the -p <

port

> option with

autoconf_cim_component.sh. This is optional and by default the openwsman is configured to run on port 443.

NOTE: To successfully use openwsmand and sfcbd services on systems running the supported Linux server operating

system with SELinux enabled, use the following commands:

• openwsmand

#grep openwsmand /var/log/audit/audit.log | audit2allow -M mypol

#semodule -i mypol.pp

• sfcbd

#grep sfcbd /var/log/audit/audit.log | audit2allow -M mypol

#semodule -i mypol.pp