CLI Guide

name=value pair 1 name=value pair 2 Description
NOTE: If you are importing a
PKCS#12 keystore, specify the type
and password of the certificate.
Restarting Server Administrator web
server is optional, but the uploaded
certificate comes to effect only after
restarting the web server.
NOTE: An error message is displayed
if you either type an invalid PKCS file
name or an incorrect password.
attribute=<ciphers> setting=<valid ciphers text value>
Allows you to choose the ciphers that support
the web server while configuring. SSL
provides a secure connection between the
web server and the browser. The connection
service does not start if an invalid cipher suite
is set.
NOTE: If an incorrect cipher value is
set and the connection service fails
to start, use the CLI command
prompt or manually set the valid
ciphers and restart the connection
service.
attribute=<sslprotocol> setting=<valid sslprotocol values are
TLSv1.1| TLSv1.2| TLSv1.1, TLSv1.2|
Allows you to set the web server SSL
protocols configuration from the valid values.
The changes to take effect after web server
restart.
attribute=<port> setting=<valid port value>
Sets the number of secure ports that you
want Server Administrator to use. The port
value range from 1024 to 65535. The default
port for Server Administrator is
1311.
attribute=<ipaddress> setting=<valid Binding IPAddress value>
Sets by default the web server to incoming
browser requests on ALL IP addresses.
However, for increased security you can
specify a single IP address or,
ALL IP
addresses. An error message is displayed on
an invalid entry of the configurable Bind List
of IP Address. For the changes to take effect,
restart the web server.
attribute=<sessiontimeout> setting=<valid Session Timeout value
between 1– 30>
Allows Server Administrator to time-out if
there is no user input for a specified number
of minutes. Users whose sessions time-out
must log in again to continue.
An example command to set the URL launch point is as follows:
omconfig preferences webserver attribute=seturl host=<name, ip, fqdn> port=<number>
The host input must contain a valid IPv4 or IPv6 address, or a valid host name.
An example command to set the signing algorithm value is as follows:
omconfig preferences webserver attribute=signalgorithm setting=MD5
92
Omconfig Managing Components Using The Instrumentation Service