CLI Guide

name=value pair 1
config=
name=value pair 2 Description
failovernw=none | lom1 | lom2 | lom3 | lom4
| all
none: Configures the failover network to none.
lom 1: Configures the failover network to lom 1.
lom 2: Configures the failover network to lom 2.
lom 3: Configures the failover network to lom 3.
lom 4: Configures the failover network to lom 4.
all: Configures the failover network to all loms.
NOTE: The failovernw option is supported on
PowerEdge12G systems onward. Configure both
primarynw and failovernw to set the
nicselection. The primarynw and failovernw
options cannot have the same value.
NOTE: Configure both primarynw and
failovernw to set the nicselection. The
primarynw and failovernw options cannot have
the same value.
NOTE: Failovernw requires license to configure
the ports. If the appropriate license is not installed
or has expired, the system displays an error
message. For more information, see Dell License
Manager at dell.com/openmanagemanuals.
ipaddress=IP
Sets the IP address if you have selected static as the IP
address source for the BMC LAN interface.
subnet=Subnet Sets a subnet mask if you have selected static as the IP
address source for the BMC LAN interface.
gateway=Gateway
Sets a gateway address if you have selected static as the IP
address source for the BMC LAN interface.
ipsource=static | dhcp | systemsoftware
static: Static if the IP address of the BMC LAN interface is a
fixed, assigned IP address.
dhcp: DHCP if the source of the IP address of the BMC LAN
interface is the dynamic host configuration protocol.
systemsoftware: System software if the source of the IP
address of the BMC LAN interface is from the system
software.
NOTE: All commands may not be supported on the
system.
ipaddressv6=<IPv6 address> prefixlength=
length
Validates the IPv6 address for configuration.
gatewayv6=<value> Validates the IPv6 gateway.
ipsourcev6=static | auto
static: IPv6 address source is set to static.
auto: IPv6 address source is set to auto.
altdnsserverv6 Validates the address of the alternate DNS server for
configuration.
dnssourcev6=static | auto
static: DNS source is set to static.
auto: DNS source is set to auto.
Omconfig Managing Components Using The Instrumentation Service 81