CLI Guide

name=value pair 1 name=value pair 2 Description
NOTE: These options are applicable
only when a custom profile is
selected.
fanmode=min | max
min: Sets the fanmode to minimum power
utilization.
max: Sets the fanmode to maximum power
utilization.
NOTE: These options are applicable
only when a custom profile is
selected.
NOTE: Reboot the system for the power profiles setup options to take effect.
Omconfig Chassis Pwrmonitoring Or Omconfig
Mainsystem Pwrmonitoring
Use the omconfig chassis pwrmonitoring or omconfig mainsystem pwrmonitoring command to configure power
consumption information.
The following table displays the valid parameters for the command:
Table 54. Valid Parameters Of Omconfig Chassis Pwrmonitoring Or Omconfig Mainsystem Pwrmonitoring
name=value pair 1 name=value pair 2 Description
index=<n> NA Number of the probe or probe index (must
specify).
config=probe warnthresh=settodefault Sets the minimum and maximum warning
thresholds values to default.
warnthresh=<n > Sets a value for the warning threshold.
unit=watt | btuphr
watt: Displays the unit in Watts.
btuphr: Displays the unit in BTU/hr.
config=resetreading type=energy | peakpower
energy: Resets the system energy reading.
peakpower: Resets the system peak
power.
NOTE: This command is applicable only on selected Dell 10G systems that support PMBus.
NOTE: Power monitoring requires license to configure the power budget information. If the appropriate license is not
installed or has expired, the system displays an error message. For more information, see Dell License Manager at
dell.com/openmanagemanuals.
Default warning thresholds
NOTE:
Sensor managing capabilities vary across systems.
To set both the upper and lower power consumption probe warning threshold values to the recommended default value, type:
omconfig chassis pwrmonitoring config=probe index=0 warnthresh=settodefault
78
Omconfig Managing Components Using The Instrumentation Service