CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
NOTE: The setting onwithconsole is
supported only on Dell blade
systems.
attribute=serialport1 setting=off | auto | com1 | com3 | bmcserial
| bmcnic | rac | com1bmc
• off: Disables serial port 1.
• auto: Maps serial port 1 to a COM port.
• com1: Maps serial port 1 to COM port 1.
• com3: Maps serial port 1 to COM port 3.
• bmcserial: Maps serial port 1 to BMC
Serial.
• bmcnic: Maps serial port 1 to the
Baseboard Management Controller
(BMC) NIC.
• rac: Maps serial port 1 to the Remote
Access Controller (RAC.)
• com1bmc: Maps serial port 1 to COM
port 1 bmc.
NOTE: This command is applicable
only on selected x8xx systems.
attribute=serialport2 setting=off | auto | com2 | com4
• off: Disables serial port 2.
• auto: Maps serial port 2 to a COM port.
• com2: Maps serial port 2 to COM port
2.
• com4: Maps serial port 2 to COM port
4.
attribute=speaker setting=on | off
• on: Enables the speaker.
• off: Disables the speaker.
attribute=cputurbomode setting=enabled | disabled
CPU turbo mode can increase the CPU
frequency when the system is operating
below the thermal, power, or current limits.
• enabled: Enables CPU Turbo Mode.
• disabled: Disables CPU Turbo Mode.
attribute=uausb setting=on | backonly | off
• on: Enables the user-accessible USB
port(s).
• backonly: Enables only the user-
accessible USB port(s) located at the
back of the system.
• off: Disables the user-accessible USB
port(s).
attribute=usb setting=enabled | disabled
• enabled: Enables the USB port(s).
• disabled: Disables the USB port(s).
NOTE: Depending on the system's
hardware you can configure either
usb or usbb.
attribute=usbb setting=enabled | enabledwithbios | disabled
• enabled: Enables the USB port(s)
during system boot, without BIOS
support.
• enabledwithbios: Enables the USB
port(s) during system boot, with BIOS
support.
Omconfig Managing Components Using The Instrumentation Service 65