CLI Guide

name=value pair 1 attribute= name=value pair 2 setting= Description
attribute=bootsequence setting=diskettefirst | hdonly | devicelist |
cdromfirst | opticaldrive
Instructs the BIOS which device is used to
boot the system, and the order in which the
boot routine checks each device.
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this BIOS
setup setting.
attribute=bootmode setting=uefi | bios
• uefi: Enables the system to boot to
operating systems that support Unified
Extensible Firmware Interface (UEFI).
• bios: Enables the system to boot to
operating systems that do not support
UEFI.
attribute=bootorder sequence=aliasname1, aliasname2,.....
aliasnameN
Configures the boot sequence according to
the set aliasnames. To view the set alias
names, run the command omreport
chassis biossetup
attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this BIOS
setup setting.
attribute=hddorder sequence=aliasname1, aliasname2,.....
aliasnameN
Configures the BIOS setup hard disk
sequence according to the set aliasnames.
Changes takes effect after rebooting the
system. To view the set alias names, run the
command
omreport chassis
biossetup attribute=bootorder
NOTE: On Linux systems, user or
user groups upgraded to
administrator or administrator
groups cannot configure this BIOS
setup setting.
attribute=cstates setting=enabled | disabled
• enabled: Enables the processor to go
into a deep sleep state when the system
is not utilized.
• disabled: Disables the processor to go
into a deep sleep state when the system
is not utilized.
attribute=conredirect setting=enabled | disabled
• enabled: Redirects the BIOS screen
output over serial port 1. Keyboard and
text output are redirected over serial
port 2.
• disabled: Turns off the BIOS console
redirection.
attribute=cpucle setting=enabled | disabled
• enabled: Enables processor C1-E after
system reboot.
• disabled: Disables processor C1-E after
system reboot.
Omconfig Managing Components Using The Instrumentation Service 59