CLI Guide

Omreport chassis pwrsupplies or omreport mainsystem
pwrsupplies
Use the omreport chassis pwrsupplies or omreport mainsystem pwrsupplies command to view properties of the
system’s power supplies. Type:
omreport chassis pwrsupplies
or
omreport mainsystem pwrsupplies
NOTE: To maintain consistency across the commands, the output format of this command has changed. Change the
user scripts as applicable.
NOTE: On servers in the Dell PowerEdge FX2 series chassis, this command is supported only if the Chassis Management
at Server Mode is set to either Monitor or Manage and Monitor in the CMC, and Server Administrator displays the
Chassis Management at Server Mode as Enabled. For more details, see Chassis Management.
For each power supply profile in the system, the values for the following fields are displayed:
• Status
• Location
• Type
• Rated Input Wattage (in Watts)
• Maximum Output Wattage
• Online Status
• Power Monitoring Capable
Omreport Chassis Remoteaccess Or Omreport
Mainsystem Remoteaccess
Use the omreport chassis remoteaccess or omreport mainsystem remoteaccess command to view general
information on baseboard management controller or integrated Dell remote access controller (BMC/iDRAC) and remote access controller
if DRAC is installed. Type:
omreport chassis remoteaccess
or
omreport mainsystem remoteaccess
NOTE:
To maintain consistency across the commands, the output format of this command and the subsequent
command levels has changed. So, you may have to change the user scripts as applicable.
The output of the omreport chassis remoteaccess or omreport mainsystem remoteaccess command lists each of the
valid parameters as displayed in the following table:
Table 30. Valid Parameters Of Omreport Chassis Remoteaccess Or Omreport Mainsystem Remoteaccess
name=value pair Description
config=additional Reports the current state of IPv4 and IPv6 addresses on iDRAC.
config=advsol Reports advanced BMC/iDRAC or remote access information on a serial over local area network (LAN)
connection.
config=nic Reports BMC/iDRAC or remote access information for the LAN.
config=serial Reports serial port information for BMC or remote access.
config=serialoverlan Reports BMC/iDRAC or remote access information on a serial over LAN connection.
omreport Viewing System Status Using The Instrumentation Service 37