CLI Guide

BIOS setup groups
The following table lists the available groups of the BIOS setup parameters on PowerEdge systems.
NOTE: Based on the hardware configuration, the attributes may vary in a specific group.
Table 13. BIOS Setup Groups
Group Description
BIOS Option Settings Controls the BIOS start settings when bootmode is set to bios.
Boot Settings Controls the system boot settings when bootmode is set to bios.
Integrated Devices Controls the devices integrated on the system board.
Memory Settings Controls the system memory settings.
Miscellaneous Settings Controls some miscellaneous system settings.
Network Settings Controls the network settings of the system.
One-Time Boot
NOTE: This group is not
supported on 13G systems.
Supports one-time boot to a specified device.
Processor Settings Controls the processor settings of the system.
SATA Settings Control the embedded SATA ports settings.
Serial Communication Controls the Serial Communication options.
Slot Disablement Controls the system slots that are present on the system.
System Information Displays the information that uniquely identifies the system.
System Profile Settings Controls the power management settings.
System Security Controls the security features of the system.
UEFI Boot Settings Controls the system boot settings when boot mode is set to uefi.
Omreport Chassis Currents Or Omreport Mainsystem
Currents
This command is no longer available through Server Administrator.
Omreport chassis fans or omreport mainsystem fans
Use the omreport chassis fans or omreport mainsystem fans command to view the fan probe status and settings. Type:
omreport chassis fans index=n
or
omreport mainsystem fans index=n
The index parameter is optional. If you do not specify the index, Server Administrator displays a summary of status, readings, and
thresholds set for any fan probes that are present on the system. If you specify the index, Server Administrator displays a summary for a
specific fan probe.
NOTE:
On servers in the Dell PowerEdge FX2 series chassis, this command is supported only if the Chassis Management
at Server Mode is set to either Monitor or Manage and Monitor in the CMC, and Server Administrator displays the
Chassis Management at Server Mode as Enabled. For more details, see Chassis Management.
omreport Viewing System Status Using The Instrumentation Service 25