CLI Guide
Syntax
omconfig storage globalinfo
action=setremainingratedwriteendurancethreshold type=<sassata| pciessd>
threshold=<1-100>
Example to Settings supported for different threshold values for SAS, SATA and PCIe SSDs. The omconfig
command syntax for Threshold RRWE value is set between 0 to 100.
NOTE: The RRWE SMART attribute is not supported for SSDs connected to software RAID
Controllers.
Example
omconfig storage globalinfo
action=setremainingratedwriteendurancethreshold type=sassata threshold=0.
Omconfig Connector Commands
The following table displays the omconfig command syntax required to execute connector tasks.
Table 215. omconfig Connector Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage connector
action=rescan controller=id connector=id
Omconfig Rescan Connector
Table 216. Omconfig Rescan Connector
Description Rescans a controller connector. This command rescans all connectors on the controller and is therefore
similar to performing a controller rescan.
NOTE: This command is not supported on SAS controllers.
Syntax omconfig storage connector action=rescan controller=id connector=id, where
id is the controller ID and the connector ID as reported by the omreport command. To obtain these
values, type
omreport storage controller to display the controller IDs and then type
omreport storage connector controller=ID to display the IDs for the connectors attached
to the controller.
Example to Rescan connector 2 on controller 1.
Example
omconfig storage connector action=rescan controller=1 connector=2
Omconfig cachecade commands
The following table displays the omconfig command syntax required to execute cachecade tasks.
Table 217. omconfig Cachecade Commands
Required Command Levels
(1, 2, 3)
Optional name=value pairs
omconfig storage cachecade
action=blink controller=id cachecade=id
action=unblink controller=id cachecade=id
action=deletecachecade controller=id cachecade=id [force=yes]
action=resize controller=id cachecade=id pdisk= <PDISKID>
Omconfig storage commands 173