CLI Guide

In this syntax, n is a user-specified alphanumeric string.
Example to Reset the thresholds for temperature probe 3, residing in the enclosure attached to connector 2 on
controller 1, to the default values.
Example for SCSI, SATA,
and ATA controllers
omconfig storage enclosure action=resettempprobes controller=1
enclosure=2 index=3
NOTE: Here, temperature probe 3 resides in the enclosure attached to connector 2 on
controller 1.
Omconfig Set All Temperature Probe Thresholds
Table 203. Omconfig Set All Temperature Probe Thresholds
Description Sets the minimum and maximum warning temperature thresholds for all temperature probes in the
enclosure.
NOTE: This command is not supported on SCSI RAID controllers.
Syntax
omconfig storage enclosure action=setalltempprobes controller=id
enclosure=<ENCLOSUREID> minwarn=n maxwarn=n, where id is the controller ID. The
<ENCLOSUREID> variable specifies the enclosure.
In this syntax, n is a user-specified alphanumeric string.
Example to Set the thresholds for all temperature probes residing in enclosure 3 attached to connector 2 on
controller 1, to 10 and 40 degree Celsius.
Example for SAS
controllers
omconfig storage enclosure action=setalltempprobes controller=1
enclosure=2:3 minwarn=10 maxwarn=40
Omconfig Reset All Temperature Probe Thresholds
Table 204. Omconfig Reset All Temperature Probe Thresholds
Description Resets the minimum and maximum warning temperature thresholds back to their default value for all
temperature probes in the enclosure.
NOTE: This command is not supported on SCSI RAID controllers.
Syntax
omconfig storage enclosure action=resetalltempprobes controller=id
enclosure=<ENCLOSUREID>, where id is the controller ID. The <ENCLOSUREID> variable specifies
the enclosure.
In this syntax, n is a user-specified alphanumeric string.
Example to Reset the thresholds for all temperature probes in enclosure 3 attached to connector 2 on controller 1.
Example for SAS
controllers
omconfig storage enclosure action= resetalltempprobes controller=1
enclosure=2:3
Omconfig Blink
Table 205. omconfig Blink
Description Blinks the light-emitting diodes (LEDs) on the enclosure.
Omconfig storage commands 169