CLI Guide

Syntax omconfig storage controller action= importforeignconfig controller=id, where id is the
controller ID as reported by the omreport storage controller command.
NOTE: This command is supported only in firmware version 5.0.x.
Example to Import foreign configurations on controller 1.
Example
omconfig storage controller action= importforeignconfig controller=1
Omconfig Import Or Recover Foreign Configuration
Table 183. Omconfig Import Or Recover Foreign Configuration
Description Imports and recovers all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= importrecoverforeignconfig controller=id, where id
is the controller ID as reported by the omreport storage controller command.
NOTE: This command is supported on firmware version 5.1.1 and later.
Example to Import foreign configurations on controller 1.
Example
omconfig storage controller action= importrecoverforeignconfig controller=1
Omconfig Clear Foreign Configuration
Table 184. Omconfig Clear Foreign Configuration
Description Clears or deletes all virtual disks that reside on physical disks newly attached to the controller.
Syntax omconfig storage controller action= clearforeignconfig controller=id, where id is the
controller ID as reported by the omreport storage controller command.
NOTE: This command is supported only in firmware version 5.0.x.
Example to Clear foreign configurations on controller 1.
Example
omconfig storage controller action= clearforeignconfig controller=1
Omconfig physical disk power management
Table 185. Omconfig physical disk power management
Description Manages the power of physical disks in a controller by spinning down hot spares, configured drives, and unconfigured
drives.
Syntax
omconfig storage controller action= setpdiskpwrmanagement
spindownunconfigureddrives= <enabled | disabled> spindownhotspares=<enabled |
disabled> spindownconfigureddrives=<enabled | disabled> idlec=<enabled | disabled>
spindowntimeinterval=<30 to 1440>(minutes) spinupstarttime=<HH:MM:AM/PM>
spinuptimeinterval= <1 to 24>(hours), where id is the controller ID as reported by the omreport
storage controller command.
NOTE: On PERC 7 controllers, only spindownunconfigureddrives, spindownhotspares, and
spindowntimeinterval parameters are supported.
NOTE: You can specify spinupstarttime and spinuptimeinterval only when you set
spindownconfigureddrives=enabled.
Omconfig storage commands 163